Error when running Non-uniform Refinement

3D Refinement
1

Having a error come up when trying to run the non-uniform refinement in Version 2.0 (beta). I’ve attached an image of the error (I can send information on the inputs if needed). Any ideas what might be causing the error?

CryoSparc_Issue_1.png1913×886 141 KB

2

Hello,

It looks like you may not have connected some of the required inputs. Could you double check and let me know if that was not the case?

Hope that helps!

Best,
Ali

3

Sorry I thought I had replied

CryoSparc_Issue_1_InputMap.png1911×886 93 KB
to this earlier.

Here are my two inputs, just the map and particles.

4

CryoSparc_Issue_1_InputParticles.png1890×810 75.8 KB

5

Hi,

The error might be caused by the inputs not being explicitly connected to the NU-Refinement job - if you click on the Inputs and Parameters tab of the NU-Refinement job that failed, it should show you that the inputs are actually connected to the job.

Best,
Ali H.