Hi,
When comparing jobs, all the custom parameters of the compared jobs are shown. If there are a lot of custom parameters, this can be a bit visually confusing.
To see the differences at a glance, it would be useful if the parameters that differ between the compared jobs were visually highlighted - or perhaps just add an additional filter - e.g. all, custom and non-identical.
Cheers
OIi
nice “O-EM learning rate init = 1” do you like that at the max of (0-1) “1” to get the most diverse 3D classes ?
Agree, some of these jobs such as 3D Classification; it is really helpful to run a few jobs with different settings and it is not clear what they are until a few jobs run.
Not for everything, but yes - setting the learning rate to a fixed value of 1 is sometimes useful to maximize diversity and minimize time to convergence. Another one of those parameters that needs some empirical tweaking
Hi @olibclarke ,
We’re working on improvements to the comparison view and will be sure to incorporate this feedback. Thanks!
- Suhail
