Assistance with Filament Tracer Not Selecting Filaments

Hello cryoSPARC community,

I’ve come across a few posts about issues with the Filament Tracer not selecting filaments, and I seem to be experiencing a similar problem. I’ve tried adjusting several parameters, including keeping the hysteresis low and high thresholds at their default values or reducing them, and testing both template-based and template-free methods.

Unfortunately, as shown in the attached screenshot, the filaments are still being completely ignored.

I would greatly appreciate any suggestions on how to improve this.

Thank you!
Best regards,
Leti

Hello,

Can you add a screenshot of what you tried? And can you show what templates you tried?

Thanks